How to Troubleshoot a Pixter Touch Screen

Change Batteries

• 1). Remove the screw from the battery case on the back of the device with a Phillips screwdriver.
  
  
• 2). Remove the battery case and the four AA alkaline batteries.
  
  
• 3). Insert four new batteries and place the battery case back on. Screw the battery case back into place.
  
  

Recalibrate Screen

• 1). Turn the device on and locate the calibration hole on the back. It is located on the upper-left side of the device.
  
  
• 2). Push the stylus into the calibration hole and hold it there. Turn the Pixter over (while still holding the stylus in the calibration hole) and wait until you see two "+" symbols appear on the screen.
  
  
• 3). Remove the stylus from the calibration hold and touch it to the "+" symbol on the upper-left side of the screen. Then touch the "+" on the lower-right side of the screen.