The best magazine
- 1). Sand and polish your metal. Make sure that all scratches have been sanded away and there is no rust on your piece. Polish your metal to clean it of any small metal shavings from sanding.
- 2). Wrap several pieces of tape around the circumference of your wire end-brush drill bit. Leave the end free of tape. This will keep your brush's bristles from fanning out during the process and ensure exact and uniform swirls.
- 3). Apply cutting oil to the surface of your metal. Place the piece into your vice to hold it in place.
- 4). Attach your wire end-brush drill bit to your drill or Dremel. With even pressure, press the brush to the surface of your metal. Check your results as your apply more pressure to achieve the swirls you like.
- 5). Wipe down your piece with rubbing alcohol immediately after to prevent rusting.
Source: ...