The best magazine
- 1). Clean the can. Rinse it out with water and let it dry upside down on a dish rack.
- 2). Jab your scissors carefully into the top of the soda can just below the rib. Cut the top off, being very careful not to cut yourself on the sharp edge. Maintain a straight cut so that the edge is smooth.
- 3). Mark the eight striped vertical cuts you'll be making. Make a tiny perpendicular snip into the the can. Make another snip directly across the can from your first snip. Then make a snip halfway between your two snips on one side, and repeat by making another snip directly across from that one. You should have four cuts evenly apart from each other. Imagine they would form a cross if connected. Make the remaining four snips by making a cut exactly halfway between each existing cut. Go around clockwise to keep track of your cuts.
- 4). Extend your snips into vertical cuts all the way down to the bottom of the can.
- 5). Bend the strips down, away from the can's bottom, and create a crease where the strips meet the bottom. This creates the blade.
- 6). Make a very small cut with your scissors along the fold you just made on one of the blades. Cut only 1/8 inch. Repeat on each blade, cutting from the same direction each time.
- 7). Twist each blade with pliers so that the cut side of the fold is pulled forward. Twist each blade the same direction.
- 8). Poke the nail through the center of the bottom of the can to create a hole. Nail the wind spinner to the wooden stake and hammer it into the ground. If you're worried your nail won't hold the spinner on, use a washer that fits the nail head to make it more secure.
Source: ...