The best magazine
- 1). Look at the inside edge of the watch. There should be arrows to identify which of the links are removable. Place the watch on the cork board.
- 2). Each of the links is connected by two pins. To remove one link, place the pushpin on top of the appropriate pin. Use the hammer to push the pin out.
- 3). The pin may not come out completely from the hammering. If this is the case, use the pliers to pull the rest of the pin out.
- 4). Repeat Steps 2 and 3 to remove as many pins and links as necessary.
- 5). Set aside the extra links. Then set up your new, smaller watchband so that the pinholes in the adjacent links are aligned. Use the hammer to push in the pins.
Source: ...