Best Supplement for Body Builder

IP address keywords them by and then the stand blip address should they be in the same subnet your health because the interface from the active unit and the standby unit are going to be the same where to broadcast the main any doctor each other so you'd want to use to IP addresses that are used anywhere else in that subnet for the system Anna active and also forth stem address okay so we've got our three IP addresses reconfigured and we've got the standby addresses as well now the next thing we're going to do is new we haven't seen this before we're going to tell the ASA that we're going to use gig3 this guy right here for the replication the failover information means a tell me configure content on the pre active device you'll be replicated over this g3 interface had to do that we have to name it and the name me is done a little bit different then we have previously so we have some special failover commands sore as a failover lawn interface those keywords and then we're going trogons go ahead and stuff planned name for this fail overland interface and we're also going to give it a names done from global configuration mode there's reasons for this and one other reasons is there in a future now you're in this series read a little something called active failover where the configuration files it just wouldn't work if we had to do this command for failover inside a van interface configuration met do in global comfit we now called the g3 interface we've now called it fail 1 now what's the next thing you do well we need a sign IP addresses to that failover interface called fail 1 and to-do that we're going to use a nether failover command so we're going to issue the command failover interface I P will refer to the name of the interface and will simply give it the IP address that we want the system IP to be for their active unit and will use the same option on standby with the standby IP address so it might take a little bit getting used to the failover commands are not really intuitive I'll be the first one to admit that so this thing failover interface the IP address for fail 1 as the interface we.
For more information, visit this site >>>>>>> http://testcoreproadvice.com/