The best magazine
- 1). Place the lawn tractor transaxle in the "Park" position and apply the parking brake, if applicable.
- 2). Switch the ignition to the "Off" position and allow the engine to cool before performing any checks or repairs.
- 3). Open or remove the hood or protective shroud surrounding the engine. Examine the front portion of the engine and disconnect the black spark plug wire from the spark plug, located above the square-shaped valve cover labeled "OHV."
- 4). Remove the four bolts securing the valve cover to the cylinder head, using an appropriate size socket wrench.
- 5). Examine the exposed portion of the engine valve train. Slowly rotate the engine crankshaft by extending the pull starter rope.
- 6). Continue rotating the crankshaft until the bottom rocker arm fully compresses the corresponding valve spring. Grasp the topmost rocker arm to check for play. The rocker arm should be slightly loose at this point.
- 7). Check the clearance between the top rocker arm and the corresponding valve stem, located in the center of the valve spring, using a feeler gauge. If the clearance reading falls outside of the acceptable range of .005- and .007-inch, the top exhaust valve is out of adjustment.
- 8). Hold the nut securing the topmost rocker arm to the rocker stud, using an appropriate size metric wrench. Continue holding the nut in position and loosen the small screw located in the center of the rocker stud nut, using an appropriate size Torx screwdriver.
- 9). Insert a ".005" feeler gauge between the top rocker arm and the exhaust valve stem. Rotate the rocker arm stud nut clockwise, while moving the feeler gauge back and forth. Continue tightening the rocker arm nut until you feel a slight resistance when moving the feeler gauge.
- 10
Hold the rocker arm nut with a metric wrench. Tighten the center screw clockwise, using a Torx screwdriver. After tightening the center screw, remove the feeler gauge from between the rocker arm and valve stem. - 11
Rotate the engine crankshaft using the method described in Step Five. Continue rotating the crankshaft until the topmost rocker arm completely compresses the corresponding valve spring. - 12
Check the clearance between the bottommost rocker arm and valve stem, using a feeler gauge. Perform the adjustment procedure on the bottom intake valve if the clearance reading falls outside of the acceptable range of .003- and .014-inches, using the same methods outlined above. - 13
Replace the valve cover and reinstall the spark plug wire. Lower the hood or replace the engine shroud to complete the valve adjustment process.
Source: ...