The best magazine
Each cleaner will give pool owners a spotless, sun-dazzled look to their pools.
They are meant to remove leaves, sand, or dirt that settles onto pool surfaces.
Pool filtration systems only catch debris that settles into the water.
There are a few varieties of automatic pool cleaners.
The first is a suction-side pool cleaner.
Some pools already have a dedicated pipe for this type of cleaner.
It has a long moulded plastic hose that connects a cleaning unit to filter suction, plugged into an intake pipe below the pool's skimmer basket.
When the suction side unit is connected and the filter is running, the cleaner will move in a random pattern across the floor and sides of the pool.
Pulses of water will naturally propel the unit.
Brushes are attached to the underside and have the ability to detach particles of debris.
Suction carries the debris to the filter.
Owners can adjust the flow volume at the hose or on the unit.
This will allows pool owner to maximize the efficiency of their cleaner.
If the unit moves too quickly, some dirt may be missed or become stuck where the cleaner cannot reach it.
Many experts say the suction side pool cleaner is the most economical since they tap into the pool system.
Debris is removed and the wall and floors are scoured to loosen stubborn particles.
No additional parts are necessary thanks to the long connection hose.
It is also one of the least expensive types of automatic pool cleaners.
Suction side pool cleaners are the best choice for owners with existing pumps and filters that are effective and appropriately sized.
Owners need to clean and backwash filters more often since they are adding more dirt than normal to the filter.
These cleaners also use more electricity than others since the pool pump must be running during operation.
A pressure side pool cleaner has a plastic hose connected to the outtake pipe from the pool's filter system.
The unit contains a filter bag for collecting debris as it wheels around the pool randomly.
Water flow from the filer outtake separates into three sections.
One section directs flow through the sweeper tail to detach pool floor debris, making collection easier.
Another section directs the jet thrusters that propel the unit.
The last section directs water through the venturi, or the port located on the bottom of the unit that allows debris to be swept into a filter bag.
The pressure side cleaner uses pressure generated by the pool pump to propel itself around the pool.
They are mounted on wheels but do not scrub the surface as thoroughly as contact cleaners.
No stress is added to the pool filter since pressure side cleaners have their own filter bags.
Their significant cleaning power means they work for pools that contain lots of large debris.
Pressure side cleaners are moderately expensive due to the auxiliary pump that adds to the cost.
It does not have the ability to pick up very small debris and it cannot clean pool walls.
While they use electricity since they are accessing a pool pump, they clean faster than suction side cleaners to use less electric power.
Robotic cleaners are the most expensive kind with a built in motor made up a drive, pump, and processor.
They can be programmed for different sized pools with a predetermined cycle of cleaning and shut off.
They have long cords that must be plugged into an electric outlet.
After each use, the pool filter bag must be removed from the cleaner.
Since they are self-contained, robotic cleaners are the most energy efficient.
They are also the most effective because they clean the tiniest of particles off of the pool floor, steps, walls, and waterline.
Most cleaning cycles run between two and four hours.
Robotic cleaners should be removed from the pool when they are done cleaning.
Source: ...